QNAP QXG-10G1T Single-Port (10Gbase-T) 10GbE Network Expansion Card, PCIe Gen3 X4, Low-Profile Bracket Pre-Loaded, Low-Profile Flat and Full-Height Brackets are Included

No additional drivers need.

Even it says compatible with the nas I have. It didn’t work

Easy to install. Had to get drivers from the internet which was easy enough, extract into folder, and install. Brackets of different sizes included with screws.... ready to go. Heat-sink kinda small, but will see. Only up and running for 10 mins, but will see long haul use... Note: installed drivers first before installing card vs. installing card, and doing a manual search/install of drivers... On boot up, Windows detected and working immediately. Cons: No drivers included. No doc telling you where to get them.... internet search with Qnap solved this. Overall quick install. Always had good luck with Qnap equipment. Will update after all new gear installed to 10gbe, and see how the NIC is working down the road. Update March 14, 2021: Had just one minor issue with 10gbe card using the Aquantia 2.7.21.0 drivers for Windows 7. When powering my computer off, the computer would turn off normally. Then 5 or 10 minutes later the computer would start all by itself. After a couple days of this and only installing the card, I solved the issue. Several changes are made when installing the driver. First, in my bios it added the Aquantia for the QXG-10G1T network card to my 3rd boot option - I disabled this. Next, in my Windows 7 (Device Manager) looking under "Network Adapters", double clicking on Qnap QXG network card, going to "Power Management" tab at the top right of the box. Click on that, and UN-check the box that says allow the device to wake the computer, then close the boxes out back to your normal Windows desktop. After this, the strange behavior will stop and I was back to normal.

Performs exactly as expected.

TS-453Beで使用するために購入しました。 本体のカバーを外し、ブラケットを付け替えて取り付けるだけなので簡単でした。 取り付けた後、本体の電源を入れればそのまま使用できるようになります。 ＰＣ側が５Ｇなので速度はこんなものでしょう。 大きなファイルをコピーする時とても快適になり満足です。