Lian Li O11DMINI-1 Vertical GPU Bracket KIT /PCIE 4.0 / White -O11DMINI-1W-4 White PCI-E 4.0

面倒です。これに付きます。 ネジが多すぎて外すのが面倒です。 電動ドライバーがないと話にならないでしょう。 また取り付け終わっても余ったパーツが無になるので、 これ必要だったのか？となりました。

Fits my O11 mini air case, and it would fit the O11 dynamic mini aswell, you can adjust the gpu bracket 3x to fit your cpu cooler so its quite flexible. And no need to remove the MB to replace the old back panel. Easy instal.

Everything was included in the open box purchase and allowed me to finish my build. The GPU looked so much better vertically with the fans out.

Pros: *Very easy to install in a O11 mini - literally takes 2 minutes *Thumb screws only for install *Leaves the bottom two PCIe slots open on a full size ATX mobo, which is nice *Has slots in the bottom plate for more airflow to the GPU *Overall is pretty secure and solid when installed properly, my GPU sits nice and level *GPU fans sit at least 2 inches from the side glass (and thats with a 3 slot GPU), plenty of room for cooling. I have already confirmed no change in temps for my GPU. *Bridge cable appears to be decent quality and is also flexible enough to move around a little. Cons: *If you have a current gen GPU (RTX 4000 series in particular) you are definitely going to lose the rear fan slot - look at my pic (thats an MSI gaming trio RTX 4070ti). The rear fan doesn't even come close to fitting with my GPU. I could install the fan on the outside of the case, that is actually an option and there is a slot to get the fan wires back through into the case, but I'm not sure yet if I want to do that or how it would look. *One of the tabs on the left side of the mount (that interlocks with the case) is located where the mobo I/O shield is. This shouldn't be there because it actually interferes with installation. I had to flatten it out with pliers to get it to install correctly. I guess it would install right if you put this mount in BEFORE your motherboard install, but otherwise it doesn't. *Its expensive for what it is. There are a lot of whole cases that don't cost this much. But if you have a O11 mini and you like the look, its worth having the one that is made specifically for this case. NOTE: Depending on your GPU you may have to loosen the little screws holding the PCIe port down to the bottom plate, mine was too far back and the GPU wouldn't mount up properly. For a second I thought it wasn't going to fit, but luckily the port position can be slid forward/backward by a few millimeters as needed.

The bracket makes the gpu sit to high and it pushes on the rear fan. A revision should be made where the gpu position can be moved up and down to allevate the problem with it pushing against the rear fan. The gpu bracket can be moved side to side for better clearance and airflow between the gpu and the side panel, I just wish the gpu position could be moved up and down as well. Overall not bad aside from the screw breaking, but at this point it would be too much a pain in the butt to try and remove the screw and ship it back for a replacement so it is what it is. Id recommend this to anyone who thinks its neat but thats all it really is, is just a neat thing. it remains to be seen if it will help with cooling.